Spline Command

The SPLINE command creates a particular type of spline known as a
nonuniform rational B-spline (NURBS) curve. A NURBS curve produces
a smooth curve between control points.




1. Choose                 Draw, Spline.
                                         or
2. Click                    the Spline icon.
                                        or
3. Type                    SPLINE at the command prompt
                                Command: SPLINE
4. Pick                     A start point for the spline
                                Object / <Enter first point>: (pick point)
5. Pick                     Points until youare done drawing splines
                                Enter point:(pick points)
6. Press                   Enter or close to complete the spline
7. Pick                    Starting tangent point for the spline
                               Enter start tangent (pick point)
8. Pick                    Ending tangent point for the spline
                               Enter end tangent: (pick point)